Installation Guide

INSTALLATION GUIDE
For further assistance, contact the support team at [e-mail]
DOCUMENT DATE: 05/27/21
B4002.1026 - RED KOMODO CANON 0.71x EXPANDER SUPPORT
The RF mount on the Komodo is a sprung mount
system, and relies on small springs inside the
mount to pull the adapter into the right place.
If the adapter support is installed incorrectly, it can
result in the lens adapter being pushed or tilted in
the wrong direction, which can result in focus and
other optical issues.
The following installation sequence must be
followed in order to ensure that the adapter is
supported correctly on the camera body.
You will need to use a 2.5mm Hex Key.
Step 1 - Prepare the RED Komodo with the required plates. Ensure all the plates are secured and tight.
Step 2 - Install the Canon adapter into the camera, allowing it to twist onto the camera body and click
into place.
Step 3 - Present the support to the Canon adapter. Using the 2.5mm hex key, mount the shorter
support crews (B) into the mounting holes on the adapter but do not tighten fully
Step 4 - Insert the longer mount screws (A) and secure the adapter to the side & top plates.
Step 5 - Tighten up the mounting screws (A) finger tight, and then tighten all screws fully using a
criss-cross pattern, including the support screws.
Step 6 - To remove the support. First, loosen the mounting screws (A) before loosening the two
captive screws (B) on the bottom of the adapter.
A
A
A
A
B
B
A - Mount Screw - M3x10mm - 2.5mm Hex
B - Support Screw - M3x6mm - 2.5mm Hex