User guide

131
Chapter 11 – Presentation Properties
• RF channel scan file: Choose an RF channel scan XML file to associate with the presentation. All RF In
states in the presentation will use this channel scan file. If you specify a different channel scan file in an RF
In state, the RF channel scan file in Presentation Properties will change as well.
Note: A player can only contain a single RF channel manifest at any one time. Playing the presentation
associated with the RF channel scan file will overwrite any previous RF channel configuration on the player.
Furthermore, if you use a Tuner Scan state to create a new RF channel manifest while the presentation is
running, the RF channel manifest specified in Presentation Properties will be overwritten.
• Delay schedule change until current media item complete playback: By default, a player will switch
from one scheduled presentation to another at the specified time, without regard for what is currently playing
in the current presentation. Check this box to have the player wait until a media item completes playback to
switch to a new scheduled presentation. For multi-zone presentations, the first media item to complete
playback, no matter the zone, will trigger the scheduled presentation change.
I/O
Click Input or Output next to each GPIO port to indicate whether the port is sending or receiving information.
Interactive
Set any of the following:
• Serial: For each serial port: Port (number), Baud rate, Data bits, Parity, and Stop bits. Toggle between Binary and
ASCII mode (Protocol), and set EOL characters (CR, LF, LF + CR) for Send and Receive EOL. Check the Invert
Signals checkbox to invert the send pin and receive pin of the serial port.
Note: the standard part is port 0 and the 5V TTL port is port 1.
• UDP: Set the UDP Destination Address (type below Specific IP Address in dotted quad form, or click All
devices on the local subnet), the UDP Destination Port, and the UDP Receiver Port.
• Touch: Select a cursor option to set whether the cursor is always hidden, always visible, or present only if there is
more than one touch region on the screen (auto display cursor). Check the Flip coordinates checkbox to reverse
the coordinates of the check screen. Use this option only if the touch screen coordinates appear to be reversed.