User guide

42
Chapter 3 – Creating Presentations
a. First scanned channel: Displays the first channel detected during the channel scan (i.e. the smallest
detectable channel number).
b. Channel name: Displays the channel with the specified name. To use this option, you must first specify a
“ScanResults.xml” file in the Specify RF channel scan file field.
c. Virtual channel: Displays the channel based on its
virtual number:
i. Current virtual channel: Manually enter the
virtual number of the channel. You should only
use this number if you are familiar with the
channel map of the cable source.
ii. Select different virtual channel: Select the
virtual number of the channel based on the
results of the channel scan. To use this option,
you must first specify a “ScanResults.xml” file in
the Specify RF channel scan file field.
d. User variable: Displays the channel based on the value
of a User Variable. The system software can recognize
both channel name and virtual channel number as the
value of a User Variable. Before you can enable this
option, you must first designate one or more User
Variables.
3. In the On entry to this state section, choose the behavior of the RF In state:
a. Remain on last tuned channel: Choose this option if you would like the player to remain on the same
channel that was displayed the last time the player was in the RF In state. The state will use your Select
channel settings if it is the first time the presentation is entering the RF In state.
b. Retune as specified above: Choose this option if you would like the player to retune using your Select
channel settings every time the presentation enters the RF In state.