Instruction Manual

2.Press MODE button on the main unit until FM icon appears on the

display to enter Radio mode.

3.Press / button to fine tune the radio frequency.

4. Press and hold / button for searching radio frequency

automatically.

Notes:

-Manual tune to select weaker stations that might be by skipped

during automatic tuning

-If the automatic tuning does not stop on the exact frequency of the

station, for example, it stops on 100.8MHz instead of 100.6MHz, use

the manual tuning method to fine tune to the exact frequency of the

desired station.

-During FM Radio mode, if you plug USB or SD/MMC card into the

unit, the play mode will automatically change to USB or SD playback

mode.

Preset Stations

The unit allows you to store up to 30 FM stations for easy recall at

any time.

1.Tune to the radio station you want to store in memory by using

or button

2.Press RPT/MEM button, the memory channel number ”P 01” will

show on the display, meanwhile, the Radio icon “FM” flashes

simultaneously

3.Press / button to select the channel number you desire to set.

4.Press RPT/MEM button again to confirm the preset location.

5. Repeat steps 2-4 to store more stations if necessary.

Recalling Stored Preset Stations

1. Press PRESET button on the unit during Radio mode to enter the

radio memory selecting mode.

2. Press / button to select the preset channel

USB/SD OPERATION

1. Slide the Power ON/OFF switch to ON position to turn on the unit.

2. Connect your USB device or SD/MMC card to the unit to access

“USB” or “CARD” mode, the relevant “USB” or “CARD” icon appears

on the display. The USB or SD/MMC card will start playing

automatically once the contents scanning is finished.

-Press “PLAY/PAUSE” button to pause or resume playback.

-Press “VOL+” or “VOL-” button to raise up/lower the volume level.

-Press “ ” button to skip to next track or press “ ” button to the

previous track.

-Press and hold “ ” or “ ” button to search during the desired

music.

-Press “RPT/MEM” button to change the Repeat mode in the following

cyclical manner:

Repeat All (default repeat mode)→Repeat-1→Repeat older