Product Specs
Table Of Contents
MBC – WB01 Product Specifications
7 Copyright © 2018 METECA SA. All rights reserved.
• Processor
− ARM©, Cortex-M0+ CPU running at up to 48MHz
− Single-cycle hardware multiplier
− Micro Trace Buffer
• Memories
− 256KB in-system self-programmable Flash
− 32KB SRAM Memory
• System
− Power-on reset (POR) and brown-out detection (BOD)
− Internal and external clock options with 48MHz Digital Frequency Locked Loop (DFLL48M) and
48MHz to 96MHz fractional
− External Interrupt Controller (EIC), 16 external interrupts, one non-maskable interrupt
− Two-pin Serial Wire Debug (SWD) programming, test and debugging interface
− Low Power
− Idle and standby sleep modes
− SleepWalking peripherals
• Peripherals
− 12-channel Direct Memory Access Controller (DMAC)
− 12-channel Event System
− Up to five 16-bit Timer/Counters (TC), configurable as either:
− One 16-bit TC with compare/capture channels
− One 8-bit TC with compare/capture channels
− One 32-bit TC with compare/capture channels, by using two TCs
− Three 24-bit Timer/Counters for Control (TCC), with extended functions:
Up to four compare channels with optional complementary output
Generation of synchronized pulse width modulation (PWM) pattern across port pins,
Deterministic fault protection, fast decay and configurable dead-time between complementary
output
Dithering that increase resolution with up to 5 bit and reduce quantization error
− 32-bit Real Time Counter (RTC) with clock/calendar function
− Watchdog Timer (WDT)
− CRC-32 generator
− One full-speed (12Mbps) Universal Serial Bus (USB) 2.0 interface with Device and embedded Host
and 8 endpoints
− Six Serial Communication Interfaces (SERCOM), each configurable to operate as either:
USART with full-duplex and single-wire half-duplex configuration
I2C Bus up to 3.4MHz
SMBUS/PMBUS
SPI
LIN slave
− 12-bit, 350 ksps Analog-to-Digital Converter (ADC) with up to 14 channels
Differential and single-ended input
1/2x to 16x programmable gain stage
Automatic offset and gain error compensation
Oversampling and decimation in hardware to support 13-, 14-, 15- or 16-bit resolution
− 10-bit, 350ksps Digital-to-Analog Converter (DAC)
− Two Analog Comparators (AC) with window compare function
− Peripheral Touch Controller (PTC) with 256-channel capacitive touch and proximity sensing I/O
− 38 GPIO pins