Manualshelf

Full Product Manual

ManualsBrandsBrilliant Evolution ManualsBar & Strip LightsLED White Wireless Under Cabinet Light with Remote
12
8
2
WIRELESS REMOTE CONTROL
LED LIGHT BAR OWNER’S MANUAL
Model # BRRC124IR
FIG. 1 FIG. 2
1
4
5
6
7
3
FIG. 3
LOCATION OF CONTROLS:
1. ON/OFF Tap Lens
2. Light Battery Compartment
3. Remote Control
4. Power Buttons
5. Dimmer
6. Preset Dimmer
7. Timer
8. Remote Battery Compartment
INSTALLATION:
When mounting the LED Light Bar make sure
the icon is facing out, towards the remote (Fig. 3).
This will ensure that the LED Light Bar receives the
signal from the remote.
Adhesive Tape:
1. Make sure the area where you want to attach
the light is clean and clear of debris and dust.
2. Attach adhesive tape to mounting bracket (Fig. 4).
3. Place mounting bracket in desired location.
Press firmly to ensure adhesive sticks.
CAUTION: Adhesive tape may remove paint or damage surface when removed.
Screws:
1. Remove mounting bracket from light.
2. Use the mounting bracket as a guide to drill two (2) pilot holes.
Secure mounting bracket to surface with screws (included). Do not over tighten screws.
3. Attach light to mounting bracket.
OPERATING INSTRUCTIONS:
ON/OFF Tap Lens:
1. Press lens to turn light ON/OFF.
Remote Control Operation: REMOVE PLASTIC TAB FROM REMOTE PRIOR TO USE
The remote control will operate the LED Light Bar within 15 feet. The remote uses Infra Red technology. It is best to point the remote
control at the LED Light Bar. Physical objects between the remote and the LED Light Bar may interfere with the Infra Red signal. Up to 10
LED Light Bars can be controlled by one remote control.
Power Buttons:
Red – Turns LED Light Bar OFF.
Green – Turns LED Light Bar ON.
Dimmer Buttons:
When the LED Light Bar is ON:
Hold - to decrease brightness.
Hold + to increase brightness.
Preset Dimmer Buttons:
When the LED Light Bar is ON press 50% or 100%.
NOTE: Brightness level can only be controlled by the remote. Lights will default to last brightness setting.
Timer:
When the LED Light Bar is ON press desired timer option (15, 30, 60 or 120 minutes). Lights will flash to confirm setting. Reset timer by
turning LED Light Bar OFF.
Attach adhesive tape here
FIG. 4

Summary of content (2 pages)