Manualshelf

Full Product Manual

ManualsBrandsBrilliant Evolution ManualsLightingLED White Puck Light With Remote (2-Pack)
12
8
2
WIRELESS REMOTE CONTROL
LED PUCK LIGHTS OWNER’S MANUAL
Model # BRRC134, BRRC153IR
FIG. 1 FIG. 2
1
4
5
6
7
3
FIG. 3
LOCATION OF CONTROLS:
1. ON/OFF Tap Lens
2. Light Battery Compartment
3. Remote Control
4. Power Buttons
5. Dimmer
6. Preset Dimmer
7. Timer
8. Remote Battery Compartment
INSTALLATION:
When mounting the puck lights make sure the icon
is facing out, towards the remote (Fig. 3). This will
ensure that the puck lights receive the signal from
the remote.
Adhesive Tape:
1. Make sure the area where you want to attach
the light is clean and clear of debris and dust.
2. Attach adhesive tape to mounting bracket (Fig. 4).
3. Place mounting bracket in desired location.
Press firmly to ensure adhesive sticks.
CAUTION: Adhesive tape may remove paint or damage surface when removed.
Screws:
1. Remove mounting bracket from light.
2. Use the mounting bracket as a guide to drill two (2) pilot holes.
Secure mounting bracket to surface with screws (included). Do not over tighten screws.
3. Attach light to mounting bracket.
OPERATING INSTRUCTIONS:
ON/OFF Tap Lens:
1. Press lens to turn light ON/OFF.
Remote Control Operation: REMOVE PLASTIC TAB FROM REMOTE PRIOR TO USE
The remote control will operate the puck lights within 15 feet. The remote uses Infra Red technology. It is best to point the remote control
at the puck lights. Physical objects between the remote and the puck lights may interfere with the Infra Red signal. Up to 12 puck lights
can be controlled by one remote control.
Power Buttons:
Red – Turns puck lights OFF.
Green – Turns puck lights ON.
Dimmer Buttons:
When puck lights are ON:
Hold - to decrease brightness.
Hold + to increase brightness.
Preset Dimmer Buttons:
When puck lights are ON press 50% or 100%.
NOTE: Brightness level can only be controlled by the remote. Lights will default to last brightness setting.
Timer:
When puck lights are ON press desired timer option (15, 30, 60 or 120 minutes). Lights will flash to confirm setting. Reset timer by turning
puck lights OFF.
Attach adhesive
tape here
FIG. 4

Summary of content (2 pages)