Full Product Manual

WARNING:
To reduce the risk of electrical shock, do not put the unit in water or other liquid. To clean, use a soft dry cloth. Do not place or store
appliance where it can fall or be pulled into a tub or sink.
BATTERY PRECAUTIONS:
1. Use only the size and type of batteries specified.
2. Always purchase the correct size and grade of battery most suitable for the intended use.
3. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
4. Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium) batteries.
5. Replace all batteries of a set at the same time. Do not mix old and new batteries.
6. Clean the battery contacts and also those of the device prior to battery installation.
7. Do not dispose of batteries in fire.
8. Remove batteries if consumed or if product is to be left unused for an extended period of time.
INDOOR USE ONLY
ONE-YEAR LIMITED WARRANTY:
This product is warranted to the original purchaser that the product will be free from defects in materials and workmanship for a period of
one year from the date of purchase. Additional details are available at www.brilliantevolution.com.
© 2019 London Johnson, Inc. All Rights Reserved.
www.brilliantevolution.com
Made in China
BATTERIES:
If the LEDs appear to be dim the batteries need to be replaced.
REPLACING THE BATTERIES IN THE PUCK LIGHTS:
1. Remove battery compartment cover.
2. Remove old batteries (if replacing batteries).
3. Insert three (3) new AA batteries (not included)
4. Make sure to follow the battery polarity guide
when installing new batteries (Fig. 5).
5. Replace battery compartment cover.
REPLACING THE BATTERIES IN THE REMOTE CONTROL:
The remote control comes with a CR2025 battery pre-installed. Remove the plastic tab
from the remote prior to use.
This product contains a button battery. If swallowed, it could cause severe injury
or death in just 2 hours. Seek medical attention immediately.
1. Loosen the screw on the bottom of the remote control.
2. Slide out battery compartment.
3. Remove old battery (if replacing battery).
4. Insert one (1) new CR2025 battery.
5. Make sure to follow the battery polarity guide.
6. Replace battery compartment.
7. Tighten screw.
FIG. 5
PRODUCT INFORMATION CHART:
Light Output (Lumens)
Correlated Color Temperature (CCT)
Run Time
Batteries (not included)
Number of LEDs
LED Beam Angle
55
3000 (Warm White)
100 hours
AA x 3
3
120º
Wireless remote control range
Number of light controlled by one remote
Brightness settings (hold –+ to set brightness)
Timer settings (minutes)
15 feet
12
50%, 100%
15, 30, 60, 120
Dimensions: 3-3/8” diameter / 1-1/4” high