Use and Care Manual

WARNING:
Do not install this unit into combustible
enclosures. Maintain a minimum
clearance of 36 inches (91 cm) between
all sides of grill and walls or other
combustible material. DO NOT use grill
under overhead unprotected
combustible construction.
21”
6”
36”- 38”
12”
9”
12”
32”
5”
7.75”
1”
9”
1
1
”
1
1
”
Drop-in cutout dimensions for the Stainless
Steel LP Drop-In 4-Burner Grill:
Length 32” (81.3 cm)
Width 21” (53.3 cm)
Height 7 3/4” (19.7 cm)
Front View
The following are minimum dimensions
necessary to install the Brinkmann Drop-In
grills.
The rotisserie motor is located on the left side
of the grill body. A minimum of
8 inches (20.3 cm) clearance is required
between the grill lid and any surrounding
material to allow for proper functioning of the
rotisserie motor.
A minimum of 6 inches (15.2 cm) clearance is
needed from the right side of the grill body to
non-combustible materials.
8”
7.75”
6”
21
Side Trim Installation
Remove two pre-attached bolts, and attach
side trim using bolts. Repeat on opposite
side.
12
.
9
3”
13.72”
7.87”
9”
DANGER:
DO NOT store a spare LP cylinder under
or near this appliance.
Tank Retention Tray Installation
1.Drill four M6 holes according to dimensions
in illustration.
2.Attach the tank retention tray using four
M6 X 10 mm bolts.
3.Place tank in the tank retention tray, then
secure using retention screw.
Tank Retention Screw