EXTRA-LONG RUNNING SOLAR POWERED L.E.D.
HOW YOUR EMPEROR™ SOLAR-POWERED L.E.D. LIGHTS WORK READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING YOUR SOLAR LIGHT. SAVE THIS MANUAL FOR FUTURE REFERENCE. IMPORTANT: The EPA Certified RBRC® Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery contained in our product indicates The Brinkmann Corporation is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada.
ASSEMBLY INSTRUCTIONS Inspect contents of the box to ensure all parts are included and undamaged. A flathead screwdriver is required for mounting the wall bracket. 1 PARTS LIST: 1 Emperor Light Head Fixture 2 Ground Stake 3 Connector w/Point 4 Deck/Wall/Fence Mounting Bracket 5 Mounting Screws (2) 5 2 Select a location with full, direct sunlight. Shady locations will not allow the battery to charge fully and will reduce the hours of nighttime light.
Step 1 Attach the ground stake to a pointed connector. Push approximately 3" of the ground stake into the ground. If the ground is too hard, soak area with water to soften. Step 2 Insert light head into ground stake. The photocell light sensor should point away from other nighttime light sources. Step 3 Charge in direct sunlight for 10-12 FULL, SUNNY DAYS. The light will turn on automatically at night. Allow at least 10-12 cycles (i.e.
DECK/WALL/FENCE MOUNTING: Select a location with full, direct sunlight. Shady locations will not allow the battery to charge fully and will reduce the hours of nighttime light. Step 1 Mount the bracket to a deck, wall or fence using the two screws provided. Step 2 Insert light fixture with connector into bracket. The photocell light sensor should point away from other nighttime light sources. Step 3 Charge in direct sunlight for 10-12 FULL, SUNNY DAYS. The light will turn on automatically at night.
Changing Battery Step 1 Remove lens from top housing by turning lens clockwise. Step 2 With top housing upside down (solar panel facing down), push battery compartment tab and lift off battery compartment lid.
Solar lights can be left outside year round, even in cold weather. However, if you wish to store your light indoors for more than two or three days, follow these steps to prevent damage to rechargeable batteries: • Store at room temperature in a dry location. • Store solar light where it can receive some sunlight or room light each day. The battery needs light to maintain a charge during storage.
1-YEAR LIMITED WARRANTY For 1-year from date of purchase, The Brinkmann Corporation warrants the Emperor solar light against defects due to workmanship or materials to the original purchaser. The Brinkmann Corporation’s obligations under this warranty are limited to the following guidelines: • This warranty does not extend to the L.E.D. or battery.