Instructions / Assembly

1009719-H
10
Figure 10.
1-SETTING THE DETHATCH HEIGHT:
• To set the tine height select a smooth flat surface such as a
drive way, sidewalk or garage floor.
• Place a 1/2” shim board to support the front and back row of
tines as shown, the wheels must be on the flat surface.
• Use the slots in the frame bracket (19) to help level the
dethatcher
• Be sure the tines are resting on the board and tighten the 5/16”
x 1“ carriage bolts (24) and 5/16” hex nuts (28) from Figure 3.
• After step 1 be sure both mounts (20) are level with the ground
and tighten both set screws (43)
1924
20
26
Slot
2-SETTING THE SCARIFY HEIGHT:
• To set the tine height select a smooth flat surface such as a
drive way, sidewalk or garage floor.
• Use the slots in the frame bracket (19) to help level the dethatcher
• Be sure the tines are resting on the smooth surface and tighten
the 5/16”x 1“ carriage bolts (24) and 5/16” hex nuts (28) from
Figure 3.
• After step 2 be sure both mounts (20) are level with the ground
and tighten both set screws (43)
The dethatcher can be used in two ways
To set up for dethatching grass see step 1
To scarify the ground see step 2
1/2” Shim board
Flat surface
Set screw
Figure 11.
Clevis Pin 5/16” x 1-3/8”
Qty. 2
34
34
Pivot pin holes
Transport position
holes
Dethatcher in transport position
Hairpin Cotter, .08"
Qty. 2
36
To set the dethatcher into transport mode remove both 5/16” x 1-3/8” clevis
pins (34) from both the pivot brackets (15) and (18).
Rotate the dethatcher up as shown and replace both 5/16” x 1-3/8” clevis pins
(34) into the next higher set of transport holes in the pivot brackets (15) and
(18) and secure with hair pin cotter (36).
15
18
OPERATION
================================================================================================