Use and Care Manual

================================================================================================
L-1762-F10
ASSEMBLY: 40” Plug Aerator
(
PA-40 BH
)
17
2
2
18
C
STEP 4
----------------------------------
C. Insert Hitch Pin (17) in Clevis (2) and
secure with Hairpin Cotter (18). Grasp Hitch
Pin and pull forward.
D. Securely tighten all of the fasteners
installed in Steps 4-A and 4-B.
After that, securely tighten hardware
installed from Step 2-B through Step 3.
STEP 5
-----------------
Find this
hardware:
- x24 Hex Head Bolts (20) - 5/16 x 0.75”
- x24 Flat Washers (24) - 5/16”
- x24 Lock Nuts (28) - 5/16”
Now insert a Nylon Bearing (15)
into both ends of all the tube
assemblies (12 & 13).
Align Plugging Spoons (9) to each
welded plate (side opposite welds) of
all the Tube Assemblies (12 and 13) as
shown.
Run bolts through the Plugging
Spoons and secure to each tube
assembly (12 and 13) with Lock Nuts
(28) as illustrated here.
15
15
15
15
20
28
9
9
9
9
12
&
13
IMPORTANT: Rounded
part of spoon fits against
the tube to lock in place.