Use and Care Manual

================================================================================================
L-1762-F21
ASSEMBLY: 48” Plug Aerator
(
PA-48 BH
)
STEP 8
----------------------------
22
25
16
25
11
30
23
30
10
22
Combine:
- x1 Hex Bolt (22) - 5/16” x 4”
- x1 Flat Washer (25) - 5/8”
Slide the bolt assembly through one
wheel (16) (wheel hub pointing toward
the threads of the bolt) and add:
- x1 Flat Washer (25) - 5/8”
- x1 Hex Nut (30) - 5/8”
Thread the hex nut as far as possible,
still allowing wheel to rotate freely.
Continue by running the hex bolt
through holes in Lift Handle (11) (and
Axle Assembly (10) on the other end of
the Aerator).
Secure with:
- x1 Lock Washer (23)
- x1 Hex Nut (30)
Tighten the inside Hex Nut while holding
the Hex Nut next to wheel stationary.
IMPORTANT: The wheel hubs are offset to one side.
Make sure the extended offsets are installed toward plug aerator.
STEP 9
--------------------------------------
27
32
11
Insert Transport Pin (27) in rear hole
same side as the Lift Handle Assembly
(11) as shown. Secure with Nylon Lock
Nut (32).
NOTE - Moving the wheels
in and out of transport mode:
Lift handle assembly (11) will pivot and
raise / lower the wheels. This transport
pin (27) allows the handle to be locked in
place during transport.