Instructions / Assembly
0'
Hitch bracket
Tools Required For Assembly:
1- 10
11
.Adjustable
Wrench
1-
15/16
ft
Wrench
1-
13/16"
Wrench
1-
3/4"
Wrench
1- Pair of pliers
1-
1/2
11
Wrench
1-9/16"
Wrench
1 - Pair Gloves
(Leave model
plate outside)
No. 23 P-386P
"Ull Bolt
1 Used
---
No.6
P-172P ._- -==-
-~--
Coulter Axle
_
LUsed.
Z-1216-C HARD ARE BAG
• IT IS RECOMMENDED THAT YOU
CAREFULLY
READ THIS
OWNt;R~$
MANUA~
~EFOR.E
STARTING
ASSEMBLY OF THE
UNIT.
• Before starting
assembly;
arrange each kind
of
hardware into a group to ease assembly.
• Right hand (R.H.) and left hand (L.H.) are determined
from the OPERATOR'S position
while seated on the tractor.
PLOW FRAME
Refer to Fig. 1
NOTE: Securely tighten all fasteners ONLY after Plow
assembly has been completed, unless noted otherwise.
• Assemble the
two
adjusting brackets to the inside
of both beams using one
1/2
11
x
1-3/4"
hex
bolt
and
one
1/2
11
hex lock nut.
• Slip trunnion through the hole in each adjusting
bracket and insert crank through the hole in
"SIDE"of trunnion, through spacer, the
two
5/8"
jam nuts, and then thread into the threaded tube.
• Thread one jam nut against the spacer
just
enough
to eliminate any excessive movement of the crank
against the trunnion, taking care NOT to bind crank.
• Using
two
wrenches, lock the other jam nut
against the first.
• Before assembling the hitch bracket BETWEEN both
TOP VIEW - WITH HITCH BRACKET
ASSEMBLY TO LEFT SIDE
lR 2R 3R
TOP VIEW - WITH HITCH BRACKET
ASSEMBLY TO RIGHT SIDE
FIG. 1
SIDE VIEW
TABLE
1
Distance
Between
Use Hole #
Rear Tractor
Whee~~(inches
)
16-19
1R
19-21
2L
21-23
3L
Over 23
3L
--
• Secure with
two
5/8
n
x 2
11
hex bolts and
5/8"
hex
lock
nuts, 4
BETWEEN
the rear wheels on your
tractor
for the
proper position of the bracket.