Instructions / Assembly

================================================================================================
1009725-E
8
7”
11”
ASSEMBLY
STEP3
---------------------------------------------------------------------------------
Usingtherounded
measurement from the
previous step, determine the
correctClevisAssembly(68)
mountingholes.
Once the correct Clevis
Assembly (68) mounting holes
have been determined, attach the
Clevis Assembly (68) between the
Right and Left Tow
Tubes (3 & 4) using
the hardware in
PANEL02
( ) as it’s been
illustrated here.
68
3
4
32
14
25
68
4
32
14
25
3
7”
8”
9”
10”
11”
12”
13”
14”
68
3
4
32
14
25
68
4
32
14
25
3
7”
8”
9”
10”
11”
12”
13”
14”
8”
-9”
12”
-13”
10”
14”
Hitchplate
heights
between
7”&10”
have the
Clevis
(U-shaped
extension)
at the
BOTTOM
of the
bracket
Hitchplate
heights
between
11”&14”
have the
Clevis
(U-shaped
extension)
at the
TOP
of the
bracket
!
DO NOT
TIGHTEN
FASTENERS AT
THIS TIME.
Use the remaining
hardware from
PANEL02and attach the Right
and Left Tow Tubes (3 & 4) at the
3rd hole as shown here.
* Be sure to add the spacer (32) through the bolt between the
tow tubes, closest to the Brush Housing (45).
23
30
68
STEP4
----------------------------------
Tighten all hardware used in STEP1
(6CarriageBoltsandNuts)andSTEP 3
(3HexBoltsandNuts).
Using the hardware in Panel03,
attach the Hitch Pin (23) and the Hairpin
Cotter (30) to the Clevis Assembly.