Use and Care Manual

================================================================================================

1009725-E

ASSEMBLY

Using the hardware in PANEL11,

assemble Hamper Mounts (5) to Upper Side

Tubes (38) as shown here.

Assemble the following through the Upper

Side Tube (5) in the order listed below:

• Hex Bolt (15)

• Upper Side Tube (38)

• Spacer (6)

• Hamper Mount (5)

• Large Washer (34)

• Nylon Lock Nut (25)

Note: Tighten Nylon Lock Nut (25) completely and then

loosen enough so that the Hamper Mount (5) pivots freely.

STEP14

------------------------------------

Add the Vinyl Caps (24) to

Hamper Mounts (5) as shown.

Thread Pull Handle (35) onto opposite

end of the Pull Rope (37) as shown here:

STEP15

------------------------------------

Use the hardware in PANEL12

while attaching the Hamper to

the Brush Housing.

*After this is complete, detailed

instructions for attaching the sweeper

to your towing vehicle are available on

page 15.

Tie one end of Hamper Pull Rope (37)

to the middle section of the upper Rear

Hamper Tube (66).

533