Use and Care Manual
================================================================================================
1009725-E
15
ASSEMBLY
Extend Pull Rope (37) to the back of
the towing vehicle to an area that will
be easily accessible from the towing
vehicle seat. This is the area that the
Pull Handle (35) will be attached.
Allow the Pull Rope (37) to slacken
several inches.
Droop between the towing vehicle & tied point on the Hamper.
Tie 2 knots in this area of the Pull Rope and drag the Handle (35) toward the
knots. Pull to secure their position on the rope.
Clean the area of the towing vehicle
that the Pull Handle (35) will attach to.
Afx the adhesive Hook and Loop (36)
tape to the back of the towing vehicle
in the cleaned area.
CAUTION: The pull rope
and handle can get tangled in
the sweeper brushes of the sweeper
during operation.
Cut and discard any excess
rope below the two knots that
have been tied.
STEP16
-------------------------
29
66
37
35
3
37
533
35
36
Slacken
37
29
66
37
35
3
37
5
33
35
36
To Towing
Vehicle
Two
Knots
35
36
37
37
To Sweeper
37
35
• DO NOT wrap the pull rope around your wrists, ngers or ANY body parts.
• DO NOT use the pull rope while the towing vehicle is moving.
• Attach the pull rope as directed on pages 14-15 of this manual.
• Avoid overlling the hamper. Heavy loads are more difcult to dump.
• Park towing vehicle and set the parking brake before dumping material.
• Use the handle that has been provided.
•
Afterdumpingthehamper: Always make sure to fully secure the Pull Handle to
the back of the towing vehicle using the Hook and Loop tape.
TOPREVENTANYPOTENTIALINJURYORDIGITALAMPUTATION,PLEASEBEAWAREOFTHEFOLLOWING: