Use and Care Manual

================================================================================================
1009725-E
18
TOADJUSTBRUSHHEIGHT:
1. Park towing vehicle on a level, hard surface and set the
parking brake.
2. Turn towing vehicle off.
3. Measure the height of the of the mower blade.
4. Attach sweeper to the towing vehicle hitch plate as
previously described.
5. Adjust Lock Arm (1) into a slot that allows the brushes to sweep
at the same height as the mower blade:
a) Loosen (do not remove) Knob (31).
b) Apply light downward pressure to the Height Adjustment
Handle (2) while lifting up on the Lock Arm (1).
c) Move Height Adjustment Handle (2) to the desired position
and lower Lock Arm (1).
d) Tighten Knob (31) rmly.
6. Check to be sure that the Hamper is not dragging on the ground
& adjust as necessary (see ‘Leveling the Hamper’ section).
ADJUSTINGTHEBRUSHHEIGHT
---------------------------------------------------------------------------------
OPERATION
2345678910 1
2
1
31
2345678910 1
2
1
31
Normal lawn sweeping is accomplished when the brushes sweep at the same height as the mower cutting height.
IMPORTANT:Setting the brush height too low for sweeping conditions causes excessive wheel skipping and slipping.
For best performance, adjust brush height as high as possible for the material and conditions.
Higher numbers on the Lock Arm (1) decal
indicate higher brush heights.
For best performance, brush height should be set to the highest
possible number while still adequately sweeping the lawn.
2345678910 1
(41) 1009046 (Not to scale)
It is recommended to set the
brush height at a higher number
than is anticipated to be needed
and perform a short sweeping test
on the lawn. Reduce brush height
one setting at a time until the
desired sweeping performance
is achieved.
Lock Arm # Approx.BrushHeight SweepingConditions
1 to 3*
1/4” to 1”
(6.5mm to 25mm)
Extremely low-cut grass
and light material.
3 to 6
1” to 2”
(25mm to 50mm)
Mowed lawns under normal
conditions or light leaves
6 to 10
2” to 3-1/4”
(50mm to 82mm)
High grass, heavy leaves or
heavy grass clippings
*Settings 1 to 3 should be used only on very
short grass heights and light material.