Use and Care Manual

================================================================================================
1009725-E
25
MAINTENANCE
15. If Bearing Retainer (61) replacement is needed, remove Tapping Screws (63) and Dust Cover (42).
16. Remove E-Ring (53) using a medium flat tip screwdriver.
17. Remove the Lock Nuts (20) securing the Bearing Retainer.
Note: Do not let the Carriage Bolts (48) fall out of the Lower Pivot (43) side plate.
18. Remove Bearing Retainer (61)
WHEELANDDRIVEGEAR
---------------------------------------------------------------------------------
REF PARTNO. DESCRIPTION QTY
42 1008955 Dust Cover 2
44 1008959-01 Wheel Axle 2
45 1008986-10SER Brush Housing 1
46 1008987 Wheel 2
50 B-4768 5/8" Machine Bushing 4
53 F-577 5/8" E Ring 6
54 L-1744 Label, Serial No 1
56 R-2259-01 Brush Axle 1
REF PARTNO. DESCRIPTION QTY
57 R-2261 1/4" x 3/4" Dowel Pin 2
58 R-2262 5/8" Large Flat Washer 2
59 R-2263 5/8" Flat Washer 2
61 R-2289SER Bearing Retainer 2
62 R-2320 5/8" External Retaining Ring 2
63 R-2321 Screw, Tapping, #12 X 3/8 4
65 R-2485RH RH Drive Pinion (Not Shown) 1
DISASSEMBLY&INSPECTION:
IfBearingRetainer(61)replacement
is needed, continue with Step 15.
IfBearingRetainer(61)doesnotneedreplacement,
continueat‘AssemblyandLubrication’section.
Storage
Position
1. Stand the sweeper in storage position on a clean flat surface such as
a garage floor or sidewalk (do not hang hamper from clevis assembly).
2. Using a medium flat tip screwdriver, remove E-Ring (53).
3. Remove Machine Bushing (50) & Wheel (46).
4. Inspect Wheel gear & Wheel Axle hole for damage & wear.
5. Inspect Wheel Axle (44) for damage & wear.
Note: Wheel Axle (44) can be removed from the inside of the brush housing.
6. Clean any dirt or debris from the inside of the Wheel (46) and Dust Cover (42)
7. Confirm the Tapping Screws (63) holding the dust cover in place are not loose.
Warning: Do not over tighten!
8. Remove Retaining Ring (62) from recess in drive pinion gear. This example
shows the RH Drive Pinion or (65).
9. Remove Flat Washer (59) and Drive Pinion (65). Note: Cup one hand under the
Drive Pinion during removal as the Dowel Pin (57) may fall free.
10. Inspect and clean the inside of the Drive Pinion. Note that the bottom of this gear
has ‘R’ emboss into it, indicating the RH Drive Pinion.
11. Remove the Dowel Pin (57) from the Brush Axle (56) (if it has not already fallen free).
12. Inspect and clean the Dowel Pin
13. Inspect and clean the Dowel Pin hole on the brush axle.
A small rag or paper towel can be used to clean the inside of the hole.
14. Remove the Large Flat Washer (58). Inspect and clean the washer and the area around the Brush Axle (56).