Operation Manual
8
Installation Operation Denition
7
www.brinno.com
Once activated the HomeWatchCam will capture for 30 seconds, during this working
period if the Motion Sensor activated again, it will extend the capture time for more 30
seconds, whenHomeWatchCam nished the capture, all frames will be store into one AVI
le.
LED Indicator:
9-1. Initial power on stage:
A. If battery is work well, activate green LED in warm up period.
B. If battery is low, ash red LED 6 times, then power o.
C. If SD card is abnormal, ash blue LED 6 times, then power o.
D. After the machine is ready, o green LED and into Motion Sensor standby mode.
9-2. When the Motion Sensor is activated at rst three times, ash Green LED in capture
period, then disabled the green LED when the Motion Sensor is activated again.
9-3. When the machine is ready, push the power button:
A. Green LED will light on when the battery power is well.
B. Red LED will light on when the battery power is lower.
C. Blue LED will light on when the memory card is full and in looping mode.
9-4. When HomeWatchCam is powered on and in standby mode, hold the power button,
Green LED will be activated in 3 second and ash Green LED 6 times, then power o.
8
9
9
Motion Sensor Activated
Capture for 30 seconds
Motion Sensor Activated
Capture for 30 seconds
Motion Sensor Activated
Capture for 30 seconds
One single AVI.
Maximum size is 1024 frames
Green: Power status
Red: Battery status
Blue: Memory card status
LED Indicator
No Activities, capture nished.