Operation Manual

1. Insert your USB Flash Drive into any
available USB port on your computer.
Windows will automatically assign a drive
letter to the USB ash drive. Make a note
of the drive letter assigned to the USB
ash drive.
2. Start the “TimeLapse Camera Setup”
program by double clicking the
“TimeLapse Camera Setup” icon in the
“Brinno TimeLapse Camera Setup”
program group. If the program group is
not open, you can open it by using the
“Start, Programs..Brinno” menus to nd the
program group.
3. The “TimeLapse Camera Setup” program
has a number of elds that can be
modied. There are two elds that allow
the time and date to be set, and there are
three elds that allow the Custom time
interval to be set. A sixth eld is used to
tell the program which drive is to be used
to store the le with the time and date and
custom time interval data. Make sure the
drive letter in this eld matches the drive
letter in step 1. Once all the elds have
been set, hit the OK button to save the le.
Loading your Time and Date Stamp and Custom Time
Interval Setting onto your USB Flash Drive
4. Remove the USB ash drive from your
computer’s USB port. Make sure your
TimeLapse Camera is turned o, and
then insert the USB ash drive into your
TimeLapse Camera in between the four AA
batteries.
5. Turn on TimeLapse Camera. When it
detects the time and date le on the
USB ash drive it will automatically load
the data from the le, beep three times,
then turn o. The next time you turn on
TimeLapse Camera it will be set to the time
and date that were in the le. TimeLapse
Camera will also remember the Custom
interval setting that was in the le.
Once you have set up your TimeLapse
Cam you are READY to begin capturing
nature in action everywhere!
9 -
Brinno TimeLapse Camera