Instructions / Assembly

6
3. Install a Water Bottle
IMPORTANT: To prevent dry heating, do not turn on the dispenser until you complete the steps
in this procedure.
NOTE: This dispenser is compatible
with 3 and 5-gallon water
bottles. It is recommended that
you purchase water bottles
equipped with a 55-millimeter
push cap.
A. Remove the plastic seal on top of the
bottle, but do not remove the protective
cap from the water bottle.
B. Clean the bottle cap and neck with a
damp, warm cloth.
C. Lift and turn the bottle upside down and
place it securely on the bottle support
collar (1). The inside of the collar is
equipped with a probe that pierces the
water bottle cap in order to avoid spills
and bacteria entering the water.
D. Wait 5 minutes for the water tanks to ll
with water before attempting to use the
dispenser.
E. Remove air from the tanks by placing
a cup under each water tap and drain
at least 4 cups (1 liter) of water before
initial use.
1