Instructions / Assembly

OPERATION

IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During

transit, dust and odors can accumulate in the tank and lines. Dispense and

dispose at least one quart of water prior to drinking any water.

Turn the Dispenser On/Off

IMPORTANT: Before you turn the dispenser on and activate the hot and cold switches, ensure

a bottle is installed.

1. Plug in the dispenser and turn the On/Off switch to On.

2. Run water through the cold and hot water taps until water begins to dispense.

Dispense Cold Water

NOTE: Water will take approximately 1 hour after plugging in and turning on to become

completely chilled.

1. Place a drinking glass or container underneath the cold water tap and press the blue lever.

2. Release when your container is full.

Dispense Hot Water and Activate Child Safety Lock

CAUTION: This unit dispenses water at temperatures that can cause severe burns. Avoid direct

contact with hot water. Keep children and pets away from the unit while dispensing.

Never allow children to dispense hot water without proper and direct supervision.

NOTE: Water will take approximately 15-20 minutes after plugging in and turning on to reach

its hottest temperature.

1. This water dispenser is equipped with a child safety feature in order to prevent inadvertent

dispensing. To enable dispensing of hot water, either press the top and bottom of the lever or

2. Release the lever once your container is full.

Change the Water Bottle

CAUTION: Do not dispense hot, cool, or cold water with an empty bottle as you could empty the

tanks and cause the dispenser to overheat

To change an empty water bottle, simply lift and remove the empty water bottle and then follow the

steps in Installing a Water Bottle.