Instructions / Assembly

6
3. Connect a Water Bottle
IMPORTANT: To prevent dry heating, do not turn on the heating and cooling switches until you complete the
steps in this procedure.
A. Remove the plastic wrapping and cap
from a new water bottle (purchased
separately). Then clean the new bottle
with a cloth.
B. Open the cabinet door and feed the
bottle adapter tube (8) into the water
bottle. Ensure the tube hits the bottom
of the bottle.
C. For a 5-gallon bottle, place the bottle
adapter (6) over the neck of the water
bottle and press securely into place.
D. For a 3-gallon bottle, press down on the
two tabs on top of the bottle adapter
(6) and slide the cap down the probe
tubing to adjust the bottle adapter to fit.
6
6
8
E. Slide the water bottle into the dispenser
cabinet and close the door. Plug in the
dispenser.
F. Wait 5 minutes for the water tanks to fill
with water before attempting to use the
dispenser.
G. Remove air from the tanks by placing
a cup under each water tap and drain
at least 4 cups (1 liter) of water before
initial use.
NOTE: Water will not pump from
the bottle until the door is
completely closed.