Use and Care Manual

RECEIVING
Inspect the dispenser box carefully for any evidence of shipping or handling damage
before signing to receive goods. In case of shipping damage, claims should be led
emmediately with the carrier
HOW TO INSTALL AND USE
1.
2. Ensure dispenser stands upright for a minimum of 2 hours before loading water bottle.
Keep cooler unplugged until water ows all the way through faucets
3. Place dispenser a minimum of 4 inches away from the wall to ensure ventilation.
4.
5. Do not install dispenser where it will be subject to direct sunlight, heat or moisture.
6. Wipe down the water bottle cap and neck to ensure there is no debris.
How to use Child Lock Lever
When the hot water comes out, be careful not to burn yourself.
Do not allow the children to use the dispenser unsupervised.
Cautions
push in safety button to unlock, then push down to
dispense hot water
Hot water comes out if pressing down the lever with
the safety lock pressed in.
PREPARE WATER BOTTLE
INSTALLING BOTTLE
Remove the Cap Seal on the top of the bottle cap (if
necessary).
1. Place the bottle adapter probe into the bottle.
2. Slide the bottle adapter over the neck of the bottle, ensure
tube hits the bottom of the bottle and push down to secure.
3. Push bottle inside and slide door to close.
1.
2.
*TOPVIEW
Hot, Cold, & Room Faucets
Press the button on the right for Cold Water, middle for room temperature
water, & left button for hot water.
Place a cup directly below a faucet and
depress the correct lever, but be careful using the hot water. Even when a
bottle is empty, Cold Water is available, for a small volume, but hot water is
not available when the bottle is empty.
Hot | Room | Cold