Use and Care Manual

ManualsBrandsBrio ManualsKitchenModerna Self-Cleaning Advanced Bottom Loading Water Cooler

Thank you for purchasing a Brio

water cooler

Please read and understand this manual before operating your water dispenser

Retain this manual for future use

INSTRUCTION MANUAL

WATER DISPENSER

MODEL NO. CLBL720SC

Summary of content (12 pages)

PAGE 1
INSTRUCTION MANUAL WATER DISPENSER MODEL NO.
PAGE 2
TABLE OF CONTENTS SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 INTENDED USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 PRODUCT FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Touch Panel Description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Product Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
SAFETY INFORMATION WARNING: To reduce risk of injury and property damage, you must read this entire guide before assembling, installing and operating the dispenser. WARNING: This product dispenses water at very high temperatures. Failure to use properly can cause personal injury. When operating this dispenser, always exercise basic safety precautions, including the following: • Prior to use, this dispenser must be properly assembled and installed in accordance with this manual. • For indoor use only.
PAGE 4
INTENDED USE This dispenser is intended to be used in household and similar applications such as: • • Farm houses • Clients in hotels, motels and other residential type environments • Bed and breakfast type environments • Catering and similar non-retail applications This dispenser is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appli
PAGE 5
Touch Panel Description 1. Up arrow button – Press to set the time on the clock and increase temperature settings. 2. Clock/Temperature display – Shows the time and water temperature setting when setting the temperature of the hot or cold water. Also indicates when a water bottle needs to be replaced and when the dispenser is in self-cleaning mode. 3. Down arrow button – Press to set the time on the clock and decrease temperature settings. 4. 5. Hot water button – Press to dispense hot water. 6.
PAGE 6
INSTALLATION 1. Determine Installation Location A. Place the dispenser upright. B. Locate the dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet. NOTICE: Do NOT plug in the power cord until the entire installation section is completed. 3 C. Position the back of the dispenser no closer than 20 cm wall and water dispenser. 2. Install the Drip Tray and Grid A.
PAGE 7
E. Slide the water bottle into the dispenser cabinet and close the door. F. with water before attempting to use the dispenser. G. Remove air from the tanks by placing a cup under each water tap and drain at least 4 cups (1 liter) of water before initial use. NOTE: Water will not pump from the bottle until the door is completely closed. OPERATION IMPORTANT: This unit has been tested and sanitized prior to packing and shipping. During transit, dust and odors can accumulate in the tank and lines.
PAGE 8
Set the Cold Temperature Setting 1. Press and hold the down arrow button for 3 seconds until the cold water button starts to blink and the current cold water temperature appears on the display. 2. Use the up and down arrow buttons to scroll to your desired cold water temperature. The range 3. Set the Hot Temperature Setting 1. Press and hold the up arrow button for 3 seconds until the hot water button starts to blink and the current hot water temperature appears on the display. 2.
PAGE 9
TROUBLESHOOTING PROBLEM SOLUTION • It takes up to one hour after setup to dispense cold water. • Make sure the power cord is properly connected to a working outlet. The cold water is not cold. • Make sure the back of the dispenser is at least 20 cm from a wall • Make sure green power switch on back of dispenser is On. • If water still isn’t cold, call customer service at +1 844-257-4103 for assistance. • It takes 15-20 minutes after setup to dispense hot water. The hot water is not hot.
PAGE 10
CLEANING AND MAINTENANCE Use the Self-Cleaning Ozone Feature It is highly recommended that you use the self-cleaning feature on a weekly basis to sanitize tanks and water lines. To activate the self-cleaning cycle, press in the self-cleaning switch (8), hold for 5 seconds, and release. 8 The Ozone icon on the bottom-right corner of the display will begin blinking, indicating the cleaning process is underway. During the cleaning cycle, ozone is produced and injected into the water system.
PAGE 11
WARRANTY Brio (“Vendor”) warrants to the original purchaser of the Brio Water Coolers (the “Product”), and to no other person, that if the Product is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in the Product shall be free from defects in material and workmanship.