The diagram above is just for reference. Please take the appearance of the actual product as the standard. Above Counter Top-Loading Water Cooler Instruction Manual Model: CLCTTL520 Thank you for purchasing a Brio watercooler.
A: SAFETY INSTRUCTION 1. Water dispenser should be installed indoors on a level floor and kept in a dry place away from direct sunlight. 2. With adaption of distinctive thermal isolation technology, this machine can minimize thermal exchange between hot & cold water. 3. Warning: Do not damage the refrigerant circuit. 4.
C: PARTS NAME 1 2 3 4 5 6 7 9 10 11 8 (FRONT) No. 12 13 (REAR) (SIDE) PART NAME No. PART NAME 1 Push button of hot water 8 Water collector 2 Push button of normal water 9 Heating switch 3 Push button of cold water 10 Cooling switch 4 Panel 11 Power supply cord 5 Tap of cold water 12 Outlet of hot water 6 Tap of normal water 13 Condenser 7 Tap of hot water NOTE: This machine is suitable for bottle of 3 or 5 gallons. Don’t use unhealthy hard water.
D: OPERATION INSTRUCTION 1. Tear the label from the bottle. 2. Vertically insert the bottle into the bottle supporter on top of the machine. Do not plug the power cord or push the heating switch until water runs out from the tap of hot water. 3. Insert the plug to socket, then turn on the switch. Indicators light up accordingly once the machine works. 4. Vertically pull out the bottle by two hands when the bottle is empty, then replace it with another bottle of water. 5.
. Never use organic liquid to clean the machine. Strictly prohibit using water to the splash it. 6. Never turn on (off) the machine by plugging the plug to (pulling the plug out from) the socket. Never increase the length of the power supply cord to avoid fire. 7. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. 8. Never turn the machine upside-down or lean it more than 45°. 9.
F: TROUBLE SHOOTING Please check the followings before having the machine repaired. PROBLEMS POSSIBLE CAUSES ELIMINATION Not hot or cold water 1. Over consumption of hot or cold water in short time. 2. No power supply 1. Just wait a moment, then hot or cold water is available again. 2. Connect plug to socket, turn on heating or cooling switch. No water running out from taps 1. Empty bottle 2. Inlet of bottle supporter blocked by bottle seal 1. Replace it with another one. 2.
4. To remove mineral deposits: Mix 4 liters water with 200g citric acid crystals, inject into the machine and make sure the water can flow out of the hot water tap. Switch on the power and heat it about 10 minutes, 30 minutes later, drain off the liquid and clean it with water for two or three times. Generally this should be done every six months. Never disassemble this machine by yourself to avoid danger from damaged machine. H: MACHINE INSTALLATION 1-2.
The product is subject to change without notice. Please keep this manual properly. Distributed by Downtown Wholesalers, Inc. 5899 S Downey Rd.
