Instructions / Assembly

6
The packaging material used is recyclable; we recommend that you separate plastic,
paper and cardboard and give them to recycling companies. To help preserve the
environment, the refrigerant used in this product is R134a (Hydrofluorocarbon
-HFC), which does not affect the ozone layer and has little impact on
the greenhouse effect. According to WEEE (Waste of Electrical and
Electronic Equipment) guidelines, waste from electrical and electronic
devices should be collected separately. If you need to dispose of this
appliance in the future, do NOT throw it away with the rest of your
domestic garbage. Instead, please take the appliance to the nearest
WEEE collection point, where available.
H: MACHINE INSTALLATION
1-2. Loosen the screw of the right bottom angle just as the
picture shown.
3. Make a hole on the floor's or the desk's surface where
the water dispenser will be installed.
4. Fix the bracket on the floor by screw tightly.
5. Tighten the screw.
WARNING! To avoid a hazard due to instability of the appliance, it must be fixed in accordance
with the instructions.
water dispenser
bracket
The hole for
tighten screw
2 3
4. To remove mineral deposits:
Mix 4 liters water with 200g citric acid crystals, inject into the machine and make sure the water
can flow out of the hot water tap. Switch on the power and heat it about 10 minutes, 30 minutes
later, drain off the liquid and clean it with water for two or three times. Generally this should be
done every six months.
Never disassemble this machine by yourself to avoid danger from damaged machine.