Water Dispenser Installation and Operation Manual Model No.
Table of Contents Safety Information ������������������������������������������������������������������������������������������������������������������������������������� 3 Intended Use. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Safety Information WARNING: To reduce risk of injury and property damage, you must read this entire guide before assembling, installing, and operating the dispenser. WARNING: This product dispenses water at very high temperatures. Failure to use properly can cause personal injury. When operating this dispenser, always exercise basic safety precautions, including the following: • Prior to use, this dispenser must be properly assembled and installed in accordance with this manual. • For indoor use only.
Intended Use This dispenser is intended to be used in household and similar applications such as: • Staff kitchen areas in shops, offices, and other working environments • Farm houses • Hotels, motels, and other types of residential environments • Bed-and-breakfast type environments • Catering and similar non-retail applications This dispenser is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have
Indicator Panel Description 1. Power indicator – When illuminated, indicates that the dispenser is on. When blinking, indicates that the self-cleaning feature is operating. 2. Hot water indicator light – When illuminated, indicates that the dispenser is heating water. 3. Cold water indicator light – When illuminated, indicates that the dispenser is cooling water. 4.
3. Install the filters Twist each filter (parts 16 and 17) clockwise into the filter housings located inside the dispenser cabinet. The sediment filter (part 16) goes on the left, the carbon filter (17) goes on the right. 17 16 4. Connect a Water Bottle IMPORTANT: To prevent dry heating, do NOT turn the red hot-water and green cold-water switches on the back of the unit to the On position until you complete the steps in this procedure. A.
D. Slide the water bottle into the dispenser cabinet and close the door. E. Plug the unit into a wall outlet, turn the green cold-water switch and the red hot-water switch to the On position. Wait 5 minutes for the water tanks to fill with water before attempting to use the dispenser. NOTE: Water will not pump from the bottle until the door is completely closed. 5.
Dispense Hot Water and Activate Child Safety Lock CAUTION: This unit dispenses water at temperatures that can cause severe burns. Avoid direct contact with hot water. Keep children and pets away from the unit while dispensing. Never allow children to dispense hot water without proper and direct supervision. Disable the heating feature by switching the red hot-water switch to the Off position. NOTE: Water will take approximately 15-20 minutes after switching on to reach its hottest temperature.
Problem Solution • Make sure the power cord is properly connected to a working outlet. The nightlight is not working. The dispenser is noisy. The bottle is leaking. The dispenser is not dispensing water. • Make sure the night light power switch on back of dispenser is in the On position. • Ensure the dispenser is located on a hard, level surface. • The heating tube may be generating a slight sound. This is normal. • Ensure the bottle is installed correctly.
Filter Replacement Schedule Filter Type Replacement Schedule Sediment 6 months or 950 gallons Carbon 6 months or 950 gallons Function Performs a coarse filtration of original water. Removes mud, sand, iron, rust, suspensions, and impurities. Reduces chlorine, taste and odor, lead, and cysts. Replace the Filters IMPORTANT: Only replace the filters with new filters designed for this dispenser. Any other type of filter will damage the machine and void any warranty.
water switches to save power, and drain any remaining water. • Clean your cabinet, controls, bottle adapter tube, and water taps each time you change or refill your water bottle. Use a soft, clean cloth and a food-grade sanitizer or bleach. • Empty and clean the drip tray and grid as needed.
Contact Us Call: +1 844-257-4103 ©2020 DTWUSA