Use and Care Manual

INSTALL RO DRAIN CONNECTOR
WARNING CAUTION
Be sure that all electrical appliances and
outlets are turned off at the circuit breaker
before working in the cabinet area.
Please wear safety
glasses to protect
eyes when drilling.
1. Identify drain outlet location.
2. Remove protective cover from back of foam seal.
3. Knock center hole out, align holes, and attach to front plate of drain connector.
4. Allowing room for drilling, position the drain connector on sink drain pipe above drain
trap.
5. Securely tighten nuts and screws.
6. Using drain connector port as drill guide, drill 7/32” hole through wall of drain pipe. Be
sure not to penetrate opposite side of pipe, and be careful not to damage side of drain
port fitting.
COLDHOT
Note: To avoid possible drainage noise, mount drain line as low as possible on the vertical tailpiece,
or on horizontal tailpiece.
Make sure to align the drain saddle hole to the drilled hole perfectly. Mis-aligning these
two holes will block the waste water and cause membrane damage. Attach the drain
saddle to the drain pipe and tighten the two screws evenly.
Push the tubing into the Quick Connect fitting, then gently pull back on the tubing
to make sure the connection was secure.