Use and Care Manual

Filter Replacement
1. Unplug power cord.
2. Shut o the water ow by turning the
lever on the straighty valve to close.
3. Replace all the lters needed. Place a towel
under the lter to catch excess water that
drips out from the lter during changeover.
4. Once you have replaced all the lters
needed, turn the lever on the straight
valve to open water ow.
Cautions
When you use water with unsafe or
unknown quality, we recommend you to
use a lter because it can cause product
failures.
Working with your home's plumbing system can be unsafe and difficult to do correctly
without the proper training. Also, your system will need to be connected to piping in a
relatively cramped space (behind and underneath your sink) and it can be especially
difficult to adequately tighten plumbing connections in that small space without the
know-how and specific tools.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not covered under the warranty.
System Start Up
1. Turn on feed water: Slowly, turn on your Cold water supply. Open the Tee Valve
(turn counter-clockwise) to allow the raw water to enter the system. Check for leaks!
2. Wait for tank to ll: Before usage, allow the tank to ll. Tank normally takes 15 to 30
minutes to ll. When the tank is lled, the RO will shut o automatically.
4. Drain Tank: Do not use the rst tank of water! Drain it out to ush the system and
new lters. Press down the hot and cold buttons to drain the water out. Let the tank
rell again and the pure water is ready for use.
5. Clean up area: Allow the system to run while cleaning up tools and work area.
6. Check for leaks! Make sure no leaking at joints, ttings, valves, and tubing connections.