Instruction manual

BriskHeat
®
Corporation. All rights reserved
24
Centipede 2
®
Module System
Instructions
Password Management
This menu:
1. Allows a user to set-up password protect mode
2. Or log-in into admin mode (if password mode is enabled) to edit
settings.
Getting There
Main Menu Global Program Reset Default Setting
Basic Navigation
 Touch the desired field to program. See below for detailed
instructions.
 Saves Password Management changes.
 Exits out of Password Management menu without changes.
Returns to Options / Set-up menu.
Parameter Definitions
 Password Mode: Enable or disable password management mode.
When enabled, all edit menus are password protected.
BriskHeat
®
Corporation. All rights reserved
9
Centipede 2
®
Module System
Instructions
Operating the C2MOD-C Module
Understanding the Status LED
Each Centipede 2
®
Module provides basic status of your heater system with its
LED light found on the front.
 Green: Temperature is within the high and low limits, and no
alarm conditions exist.
 Blinking Red: An alarm condition exists. See Operator Interface for
status message.
 Blinking Orange: Module/zone is latched due to alarm latch condition.
See page 24 for Alarm Latch instructions.
 Blinking Green: Module/zone disabled.
 Off: Power is not supplied.
Operating The Centipede 2
®
Touchscreen User Interface
Starting Up
With the power supplied to the Centipede 2
®
Operator Interface Unit,
turn on the main power switch. The firmware version will initially be
shown on the screen.
Zone Discovery
Every time the operator interface unit is powered on, a zone discovery
procedure is executed. This procedure discovers and automatically
addresses all of the zones on the network.
 Once complete, touch the screen to continue to the Main
Menu.