Product Manual

BriskHeat
®
Corporation. All rights reserved
5
Silicone Rubber Band Drum / Pail Heaters
INSTALLATION OF HEATER
1. Verify drum surface is clean, free of weld splatter, and not damaged
in anyway.
2. Select a suitable location on the drum, below the lowest expected
content level. For almost all applications, the heater should be mounted
on the bottom 1/3 of the drum.
3. Wrap the heater around the drum. Extend the spring attached to the
metal tab; latch the spring loop onto the hook on the opposite side as
shown in Figure 1.
4. Verify there are no air gaps between the heater and the drum.
Do not use metal tab as a handhold when extending the
spring.
The heater MUST make continuous contact with the drum.
Do not overlap the drum heater onto itself or another heater.
Figure 1