Product Manual
BriskHeat
®
Corporation. All rights reserved
3
Silicone Rubber Band Drum / Pail Heaters
A person who has not read
and understood all operating
instructions is not qualified to
operate this product.
Do not immerse heater in liquid.
Keep enclosure cover tight while circuits are
alive.
Use heater only in approved locations
Keep sharp metal objects away from heater.
Failure to observe these warnings may result in
electric shock, risk of fire, and personal injury.
End-User Must Comply to the Following:
Only qualified personnel are allowed to
connect electrical wiring.
Disconnect all supply power at the source
before making any power connections.
All electrical wiring must follow local elec-
trical codes, it is highly recommended
that NEC Article 427 is followed.
Final installation / wiring is to be inspect-
ed by the authority who has jurisdiction in
the area where the heater is installed.
The end-user is responsible for providing
a suitable disconnecting device.
The end-user is responsible for providing
suitable electrical protection device. It is
highly recommended that a ground fault
circuit breaker is used.
Failure to observe these warnings may result in
personal injury or damage to the heater.
IMPORTANT SAFETY INSTRUCTIONS
Never handle the heater while
it is in operation; Always dis-
connect the heater from the
power source and allow to cool
prior to handling.
Inspect heater before use.
Do not wrap the heater over
itself.
If spillage of foreign matter
onto heater occurs, disconnect
from power source and clean
after heater is allowed to cool.
Never operate a heater without
an appropriate heat sink
(device being heated is consid-
ered a heat sink).
Fasten heater to device using
approved methods only.
Do not repair damaged or
faulty heaters.
Do not crush or apply severe
physical stress on heater or
cord assembly.
Disconnect heater when not in
use.
Use specified sized heater with
same sized drum. Do not use
for other applications.
Failure to observe these warnings
may result in personal injury or
damage to the heater.