Product Manual

SRL-ADJ & SRP-ADJ Series Instructions
BriskHeat
®
Corporation. All rights reserved
7
ADJUSTMENT OF TEMPERATURE SET-POINT
Turn dial to desired setting. Heaters designed for metal surfaces (SRL-ADJ
series) can be adjusted 50-425ºF (10-218ºC). Heaters designed for poly surfaces
(SRP-ADJ) can be adjusted 50-160ºF (10-71ºC).
NOTE: If precise temperature control
is required for your application, please
contact
BriskHeat or your local
distributor for application assistance
and product solutions.
TROUBLESHOOTING GUIDE:
Please read this guide prior to contacting
BriskHeat
®
. This guide is designed to
answer the most commonly asked questions. If you are unable to identify the
problem or need additional assistance, please contact us at
1-800-848-7673
(U.S. / Canada)
,
1-614-294-3376 (worldwide)
, or
[e-mail]
.
PROBLEM SOLUTION(S)
Heater does not warm up Verify heater is connected to proper voltage.
Check to see if there is a resistance reading (not an open circuit)
in heater using an ohm meter.
Pressure sensitive adhesive is
not adhering
Verify date of manufacture. PSA has a shelf life of 6 months.
Ensure there are no air gaps and heater is making
intimate contact with surface being heated.
Confirm:
- Medium to hard rubber roller used for install.
- Surface properly cleaned and clear from oil, dirt and
residue.
- Installation occurred above 40ºF (4ºC)
Circuit breaker is tripping Validate that the circuit breaker is capable of handling
the amp requirement of heater. The identification
label located on the power cord displays the heater’s
amperage requirement.
Examine heater and cord for any damage.
Check to see if there is a resistance reading between
power leads and the ground lead.
SRL-ADJ & SRP-ADJ Series Instructions
8
BriskHeat
®
Corporation. All rights reserved
WARRANTY INFORMATION
1055 Gibbard Ave, Columbus, OH 43201
Toll Free: 800-848-7673
Phone: [phone]
Fax: [phone]
Email: [e-mail]
PN: 11661-06 Rev 0
BriskHeat
®
warrants to the original purchaser of this product for the period of
eighteen (18) months from date of shipment or twelve (12) months from date of
installation, whichever comes first. BriskHeat
®
’s obligation and the exclusive
remedy under this warranty shall be limited to the repair or replacement, at
BriskHeat
®
’s option, of any parts of the product which may prove defective under
prescribed use and service following BriskHeat
®
’s examination, is determined by
BriskHeat
®
to be defective. The complete details of the warranty can be found
online at www.briskheat.com/t-warranty.aspx or by contacting us at 1-800-848-7673
(toll free, U.S. / Canada) or 1-614-294-3376 (Worldwide).