User Manual
10 ENGLISH
3.6 Step 6: Install fi lter-head wall-mount bracket
(see fi g. 10)
!
During assembly, note the installation dimensions, bending
radii of the hoses and dimensions of the accessories. The
system can be operated with the fi lter cartridge in either
vertical or horizontal positions. Using the mounting bracket,
it should be installed only vertically, with the “UP” arrow on
the bracket correctly positioned.
A Attach the space-saving wall mount bracket (1) in place using two
matching screws and use two wall plugs (not supplied), depend-
ing on the type of wall. Position it in an accessible place to allow
for 90° pivoting of the head for easy exchange of the fi lter.
B Engage the fi lter head (2) in the wall mount (1) using the notches
(4) on the sides of the fi lter head to connect to the arms of the
bracket.
1.
2.
3.
4.
(fi g. 10)
3.7 Step 7: Commissioning
Before use, make sure that you have followed all the steps
correctly and all the parts are fi tted. Place a suitable container
under the cartridge to catch any leakages.
A Turn on the cold and hot water supplies and check the system
carefully for any leaks.
B Open the BRITA Tap and allow water to run until the fi ltered
water runs clear and without any bubbles (at least 1 litre).
4 Replacing the fi lter cartridge
To ensure optimum performance and for hygienic reasons, the
fi lter cartridge is be replaced six months after fi rst use, irrespective
of usage. Monitor the display on the cartridge indicator at regular
intervals and be alert for the audible alarm signal that will sound at
the end of the set 180 days.
!
Read the Operating and Safety Information (chapter 9) prior
to exchange of fi lter.
NOTE
The fi lter cartridge can be pivoted by 90° in the wall mount
bracket for easy removal. When the locking handle is open,
the water supply to the cartridge is interrupted, without the
need to turn off the isolating valve.
Replacing the A 1000 fi lter cartridge (see fi g. 9):
A Open the locking handle (3).
B To release the pressure in the system, fi rst place a suitable
container under the fl ush hose to catch any water, then press the
fl ush button (5).
C Remove the exhausted fi lter cartridge (4) from the fi lter head (2).
D Insert the new fi lter cartridge (see chapter 3.5 Step 5).
E Close the locking handle (3). Open the BRITA Tap and allow
water to run until the fi ltered water runs clear and without any
bubbles (at least 1 litre).