User Manual
6 ENGLISH
C Reading the timer status
The display is activated by pressing the DISPLAY button briefl y
during operation. The remaining time until the exchange of the
cartridge is due is shown in days. If the time is exceeded, the time
is displayed with a minus sign.
D Audible signals
a Signal to replace the cartridge: A long signal sounds on the hour
every hour when there are less than 10 days before the end of
the programmed 180 day setting (15 double beeps). A shorter
reminder (5 double beeps) then sounds every 15 minutes until
the next signal.
b Reminder function: Press any button to deactivate the signal for
72 hours if you prefer to be reminded to replace the cartridge at
a later date.
c Battery change signal: When the batteries are depleted, a long
signal sounds (15 single beeps) followed by a short reminder
signal (5 single beeps) every 15 minutes until the next signal on
the hour.
d Switching the device off: This is only possible by removing the
batteries from the battery compartment.
E Activating the reset function when replacing the
cartridge
a Press the DISPLAY button briefl y to activate the display.
b Press and hold the START/RESET button for 5 seconds until a
long beep sounds.
c The last 180 days programmed appear in the display.
d The timer starts automatically.
F Changing the batteries
a After changing the batteries, a long beep sounds.
b After the beep, briefl y press the DISPLAY button to activate the
display.
c The remaining days since the last reset are now displayed.
(Caution: Only possible up to 16 hours after the batteries are
fully depleted. After this time, the device reverts back to the
factory setting and must be reprogrammed – see Point B).
G Installation
You can fi x the electronic BRITA cartridge exchange indicator to an
appropriate and dry place by using the supplied Velcro hook and
loop fastener. We recommend installing it under the sink in a posi-
tion of easy visibility. Avoid contact with water/splashes!
Technical data:
• Batteries: 2 AA (removable)
• Acoustic alarm: when batteries are low, or after 3 or 6 months
• To avoid loss of data, change the battery within 12 hours.
• After 16 hours without power, the appliance switches back to its
factory settings.
• The display automatically switches to stand-by mode after
10 seconds.
(fi g. 3)
3.3 Step 3: Installing the BRITA Tap
To install the BRITA Tap, fi rstly ensure you have all the components
required.
!
Please, make sure that there is enough room and access
under the sink to allow for the installation of the fi lter head
and cartridge, and to connect the two supplied hoses.
Determine the position for the convenient placement of the
exchange indicator.