User Manual

ENGLISH 7
WD 3010
(fi g. 4)
1.
2.
3.
4.
5.
6.
1. BRITA Tap with 3 hoses
2. O-Ring
3. Threaded Bolt
4. Joint (Is only necessary for installa-
tion of the dispenser if you directly
mount it onto your sink. If you
mount it onto your countertop-plate,
you do not necessarily need this
part. It helps stabilizing the tap at
your sink)
5. Flat Gasket
6. Flange
7. Hex nut
WD 3020
(fi g. 5)
1.
2.
3.
4.
5.
6.
1. BRITA Tap with 3 hoses
2. O-Ring
3. Shank
4. Joint (Is only necessary for installa-
tion of the dispenser if you directly
mount it onto your sink. If you
mount it onto your countertop-plate,
you do not necessarily need this
part. It helps stabilizing the tap at
your sink)
5. Flat Gasket
6. Flange
7. Hex nut
WD 3030/ WD 3040
(fi g. 6)
1.
2.
3.
4.
5.
6.
7.
1. BRITA Tap (design may differ) with
3 hoses
2. Shank
3. Base
4. Joint (Is only necessary for installa-
tion of the dispenser if you directly
mount it onto your sink. If you
mount it onto your countertop-plate,
you do not necessarily need this
part. It helps stabilizing the tap at
your sink)
5. Flat Gasket
6. Flange
7. Hex nut
First of all, dismount your existing kitchen tap.
A a) Turn off the cold and hot water supplies
b) Please make sure you release any pressure by opening all
levers.
!
No water should run through the existing kitchen tap.
c) Unscrew the existing hoses from the cold and hot water
supply.
!
We recommend placing a suitable container under the water
supply as there will be water left in the hoses which will run
down when you unscrew them.
d) Unscrew your kitchen tap – there is no standard mounting but
in general a pipe wrench will help you to dismount it.
e) Pull out both your kitchen tap and the hoses. You’re now
ready to install the BRITA Tap (see fi g. 4).
First of all, screw the shank (2) into the BRITA Tap (1).
Screw the hoses into the dispenser (see fi g. 7).
7.
7.