User guide

Route the vehicle belt 5 under the child seat

cover, between comfort foam and the child seat

shell, then through the belt slot closest to the

vehicle buckle from front to rear of the child

seat (Fig. C).

Vehicle belt must route on the • inside of the

recline bar.

Verify that the vehicle belt is not twisted and 6

then buckle (Fig. D).

Push the child seat firmly into the vehicle seat 7

while removing slack from the vehicle belt.

Lock the vehicle belt according to the 8

instructions in your vehicle owner’s manual.

Attach each Versa-Tether9

hook to separate

vehicle designated tether anchors. Remove

all slack from the tether to secure. Store

any excess tether strap webbing within your

vehicle. See pages 26 – 27.

Verify that all connections are secure, the vehicle belt is tight, and 10

the child seat is secure.

The child seat is secure when it cannot be moved more than 1 inch •

front-to-back or side-to-side at the belt path. If the child seat is not

secure, repeat this procedure or use an alternate seating position.

Lap Belt – Short Route

Figure A illustrates a • Short Route lap belt

installation.

The recline bar must be used at all times 1

with this child seat. Insert the recline bar into

the holes on the rear of the child seat. Use a

rubber mallet to tap the recline bar ends into

the holes. See page 28 for details.

You must always use the Versa-Tether when installing this child 2

seat. Loosen the Versa-Tether and place it up and over the child

seat back.

Place the child seat in the forward-facing position on the vehicle 3

seat. Ensure the bottom of the child seat shell is in full contact with

the vehicle seat and the recline bar is resting against the vehicle

seat back.

Pull the vehicle belt out and route through the 4

belt slot furthest from the vehicle buckle, from

the rear to the front of the child seat (Fig. B).

Vehicle belt must route on the • inside of the

recline bar.

Installation for Children 40-105 lbsInstallation for Children 40-105 lbs