User guide

26
27
Consult your vehicle owner’s manual for approved tether anchorage 1
locations.
Locate the tether on the back of the child seat. Place the tether 2
components up and over the child seat back.
Install the child seat using the LATCH system or the vehicle seat 3
belts according to the instructions in this manual.
Lift the tether adjuster tab to release the tether straps, then pull to 4
fully extend the tether into a “V” shape.
Locate the hooks on the strap. 5
Attach the tether hooks to tether 6
anchor(s) in vehicle (Fig. A).
For occupants less than 40 lbs *
(18.1 kg): attach one tether hook to
the designated tether anchor for the
chosen seating position.
For occupants more than 40 lbs *
(18.1 kg): attach BOTH tether hooks
to separate vehicle designated
tether anchors (Fig. A).
WARNING!
Always use the Versa-Tether. Using the tether will improve the •
stability of your child seat and reduce the risk of injury.
Attach the Versa-Tether only to tether anchors designated by •
your vehicle manufacturer as tether anchorage points. Use of
other locations is not approved or permitted.
Do NOT modify the vehicle without advice from the vehicle •
manufacturer if a tether anchor is not available.
Do NOT hook the Versa-Tether to the bottom of a vehicle seat •
adjuster.
Using the Versa-Tether Using the Versa-Tether
IMPORTANT: If your vehicle does not currently have a tether anchor
attachment, refer to your vehicle owner’s manual or contact your vehicle
man u fac tur er for assistance.
OR


A
WARNING! Never attach more than one tether hook to a
single tether anchor.
Pull the tether adjuster belt to remove all slack and ensure any 7
excess tether strap webbing is stored within your vehicle.
Verify that there is no slack in the tether strap and that the child seat 8
is properly secured.
The child seat is secure when it cannot be moved front-to-back or •
side-to-side more than 1 inch (2.5 cm) at the belt path.