User guide

14
15
Rotate the child seat into the forward-facing 8
position. Ensure the bottom of the child seat
shell is in full contact with the vehicle seat and
the recline bar is resting against the vehicle
seat back.
Verify that the LATCH strap is routed 9 under the
child seat cover and is not twisted. Attach the
remaining LATCH hook to the adjacent LATCH
anchor. (Fig. F)
The LATCH strap must be routed on the •
outside of the recline bar.
The LATCH hook MUST hook over the LATCH •
anchor (Fig. G).
Pull on the LATCH hook to confirm attachment•
Attach one Versa-Tether10
®
hook to the
designated tether anchor for the chosen
seating position. Remove all slack from the
tether strap to secure. Ensure any excess tether strap webbing is
stored within your vehicle. See pages 26 – 27
Verify that all connections are secure, the LATCH strap is tight, and 11
the child seat is secure.
The child seat is secure when it cannot be moved more than 1 inch •
front-to-back or side-to-side at the belt path. If the child seat is not
secure, repeat this procedure or use an alternate seating position.
Lap-Shoulder Belt – Long Route
Figure A illustrates a • Long Route lap-shoulder
belt installation.
The recline bar must be used at all times with 1
this child seat. Insert the recline bar into the
holes on the rear of the child seat. Use a rubber
mallet to tap the recline bar ends into the holes.
See page 28 for details.
You must always use the Versa-Tether when installing this child 2
seat. Loosen the Versa-Tether and place it up and over the child
seat back.
Place the child seat in the forward-facing position on the vehicle 3
seat. Ensure the bottom of the child seat shell is in full contact with
the vehicle seat and the recline bar is resting against the vehicle
seat back.
Pull the vehicle belt out and route through the belt slot farthest from the 4
vehicle buckle from the front to the rear of the child seat.
The vehicle belt must route • over the child seat cover and outside
of the recline bar.
Route the vehicle belt across the back of the 5
child seat continuing through the belt slot
closest to the vehicle buckle, to the front of the
child seat shell (Fig. B).
The vehicle belt must be routed • over the
harness straps on the rear of the child seat.
Route the vehicle belt around to the outside of 6
the child seat near the vehicle buckle, routing
over the child seat cover (Fig. B).
The vehicle belt must be routed on the • outside of the recline bar.
f A
b
G
Installation for Children 22-40 lbs Installation for Children 22-40 lbs