User guide

1716
Installation
Installation
Lap Belt Only Installation
• Figure A illustrates a typical lap
belt only installation.
•
When not in use, always store the
LATCH connectors in storage
pouches sewn in back of cover.
1 Place the restraint in a forward
facing position on the vehicle
seat.
2 Remove tether from pouch and
loosely attach to approved
anchorage point(s).
• See pages 18–19 for complete
Versa-Tether instructions.
• ALWAYS use the Versa-Tether!
3 Pull the vehicle belt out, then pass
it through the first belt slot, from
the front of the restraint to the
rear
(Fig. B) .
4 Route the vehicle belt around
the back of the restraint then
through the second belt slot,
from the rear of the restraint
to the front (Fig. C) .
B
A
C
5
Verify that the vehicle belt is not
twisted, then buckle ( Fig. D) .
6 While pushing the restraint
firmly into the vehicle backrest,
remove all slack from the
vehicle belt. ( Fig. E).
7 Verify that the vehicle belt is
tight and the restraint is secure.
8 Refer to Figure F to verify
correct routing of the vehicle
belt.
9 Attach Versa-Tether
®
as
instructed on pages 18–19.
D
E
F
P2315_R01e.qxd 11/7/2003 1:04 PM Page 18