User guide

2120
Using Restraint Features
Pad Inserts
The pad inserts are designed to be
adjusted to offer the child more or less
support as needed.
The two flat pads are intended for use
under the cover on the sides of the
restraint. The four foam cylinders are
intended for use under the cover and are
secured by elastic loops.
Head Pad
The head pad should be used to provide
additional padding and support for the
child’s head.
Attaching the Head Pad
Route straps through the top slots, then
over the top of the restraint (Fig. E) . Fasten
the head pad straps using the snap
buttons.
Adjusting the Head Pad
To adjust the height of the head pad, slide
it up or down as needed (Fig. F) .
Flat Pads
Cylinder Pads
Recline Bar
The recline bar allows the restraint recline
to be adjusted for comfort. Use of the
recline bar is optional.
Attaching the Recline Bar
Insert recline bar into the holes in lower
rear of restraint
prior to installation in
vehicle (Fig. A)
.
IMPORTANT: The bottom of the restraint
should be flat on the vehicle seat when
installed.
Seat Extension
The seat extension is intended to provide
extra leg support for taller children. Use
the seat extension when a child’s legs have
grown too long to allow a comfortable
seating position in the restraint alone.
Attaching the Seat Extension
Pull cover back from bottom of restraint. Insert seat extension into the
holes in front of restraint
prior to installation in vehicle (Fig. B) . Replace
cover.
Recline Bar
C
Using Restraint Features
Seat
Extension
B
A
D
E
P2315_R01e.qxd 11/7/2003 1:04 PM Page 22