User guide

2928
Care and Maintenance
Care and Maintenance
Cover Removal
1 Loosen the harness, by lifting the harness adjuster while pulling the
shoulder straps forward as far as possible.
2 Unhook the shoulder straps from the yoke, on the rear of restraint.
3 Pull upper harness straps through the shell and cover, to the front
of the restraint.
4 Remove the belly pad and pommel from the buckle.
5 Gently remove the upper portion of the cover. Be careful not to
damage the energy absorbing foam.
6 Pull the lower harness straps, buckle tongues, chest clip, and
buckle through the slots in the cover.
WARNING:
• Do not take apart or attempt to take apart the harness. It is
unnecessary and dangerous to do so.
• Never remove the buckle tongues from the harness. They
cannot be reattached after removal.
• Never remove the HUGS system from the harness straps.
7 Remove the entire cover from the restraint.
Refitting the Cover
To refit the cover, reverse Cover Removal directions. Make sure that
the shoulder straps are threaded through the chest clip and that
the harness is not twisted.
Cleaning the Cover
HAND WASH, using cold water and mild soap.
LINE DRY, to prevent cover from shrinking.
DO NOT:
• Bleach
• Machine wash
• Machine dry
Cleaning the Harness
SPONGE CLEAN, using warm water and mild soap.
TOWEL DRY
DO NOT:
• Bleach
•
Machine wash
•
Machine dry
• Disassemble the harness
Cleaning the Shell
SPONGE CLEAN, using warm water and mild soap.
TOWEL DRY
DO NOT:
•
Use abrasive cleaners
•
Disassemble the harness
P2315_R01e.qxd 11/7/2003 1:05 PM Page 30