User guide
1514
4
Route the vehicle belt under
the cover then through the
second belt slot, from the
front of the restraint to the
rear
(Fig. C)
.
5
Verify that the vehicle belt is
not twisted, then buckle (
Fig.
D)
.
6 While pushing the restraint
firmly into the vehicle backrest,
remove all slack from the
vehicle belt.
•
First remove slack from the lap
portion of the vehicle belt, then
the shoulder portion (Fig. E).
7 Verify that the vehicle belt is
tight and the restraint is secure.
8 Refer to Figure F to verify
correct routing of the vehicle
belt.
9 Attach Versa-Tether
®
as
instructed on pages 18–19.
•
ALWAYS use the Versa-Tether!
Installation
Lap-Shoulder Belt Installation
Short Route
(Recommended ONLY if vehicle belt is
too short for Long Route)
• Figure A illustrates a typical lap-
shoulder belt installation.
•
When not in use, always store the
LATCH connectors in storage
pouches sewn in back of cover.
1 Place the restraint in a forward
facing position on the vehicle
seat.
2 Remove tether from pouch and
loosely attach to approved
anchorage point(s).
•
See pages 18–19 for complete
Versa-Tether instructions.
•
ALWAYS use the Versa-Tether!
3
Pull the vehicle belt out and pass
it through the first belt slot, from
the rear of the restraint to the
front (Fig B).
Installation
D
E
Shoulde
r
Lap
B
A
C
F
P2315_R01e.qxd 11/7/2003 1:03 PM Page 16