User guide

29
5 Push the base firmly into the
vehicle seat while removing
all slack from the vehicle belt.
6 Route any excess webbing
from the vehicle belt through
the lock-off.
7 Close the lock-off plate over
the webbing and close both
lock-off tabs while pressing
firmly on the lock-off plate.
* The lock-off is properly secured
when the tabs lay flat against
the lock-off plate.
* If the lock-off will not close,
remove the excess vehicle belt
webbing and tuck it under the
base.
Installing the Base
9 Verify that the vehicle belt is tight and that the base is secure. The
base is secure when it moves less than 1 inch (2.5 cm) front-to-
back or side-to-side at the vehicle belt path.
8 Place the infant carrier into
the base and press down until
a click is heard.
* Pull up on the carrier handle to
confirm attachment.