Instruction manual

18 19
I. Fit the attachment clip to the car's anchor
ttingasshown.Makesuretoremoveasmany
twists as possible from the upper anchorage
strap. Refer to the car owner's handbook for
thelocationofthechildrestraintanchortting.
J. Tighten adjustable upper anchorage strap by
pulling adjustment strap (C) to remove slack,
but do not over-tighten causing the restraint
base to lift off the vehicle seat. This will usually
be done once the baby has been harnessed
into the seat. Roll up excess strap tightly so
the webbing is thick enough to be held in the
storage band.
HOW TO SETUP
Fully press Adjuster Button
(A) while pulling Upper
Anchorage Strap (B) to
lengthen.
Pull Adjustment Strap
to remove slack
Roll up excess strap
tightly so the webbing is
thick enough to be held
in the storage band.
B
A
Storage
Band
J
I
C
HOW TO INSTALL
DO NOT USE RESTRAINT IN REARWARD FACING MODE WITHOUT STABILISING BAR
FULLY EXTENDED.
THE UPPER ANCHORAGE STRAP MUST ALWAYS BE FITTED WHEN THE CHILD
RESTRAINT IS USED IN A VEHICLE.
ALWAYS ATTACH THE HOOK AND REMOVE THE SLACK.
Attachment Clip
Ensure Upper Anchorage Strap is tightened,
attached to the Anchor Fitting and that straps are
the same length on both sides of Attachment Clip.
Pull sash portion of seat
belt to remove slack.
A single
twist is
required in
baby use.
Do not use this
slot for baby use
installation
Feed seat belt between restraint cover and
restraint body, (see previous page).
Engage the Lock-offs to prevent the seat belt slacking.
Do not use the Lock-off if the seat buckle interferes.
Attachment Clip
Car's Anchor Fitting
Car's Anchor Fitting