Instruction manual

HOW TO INSTALL

ADJUSTING HARNESS STRAP HEIGHT & HEADREST:

FOR BABY USE REARWARD-FACING

Correcttmentoftheharnessisveryimportantasitrestrainsthebabyintherestraint.Theheadrest

mustbeinthecorrectpositionandtheharnessmusttrmlyarounduppertorsoofthebabyandbe

positioned so as to leave the baby's arms and legs free.

For babies in rear facing mode the headrest must be in the position where the top of the shoulder strap

slots are nearest to the child’s shoulders, but not lower than the child’s shoulders. Instructions for

adjusting the headrest is on the next page. If your baby has reached the lower shoulder height marker

then the restraint should be converted for “child use” (Refer to Forward Facing section starting on

page 29).

1. The shoulder straps must be in the slots which are nearest to the child's shoulders, but not lower

than the child's shoulders. There is only one set of slots so the seat will always have the shoulder

straps in place.

2. Use the Infant Safety Cushion Insert when rear facing for smaller babies until their shoulders reach

the Lower Shoulder Height Marker. Remove the Infant Safety Cushion for longer use whilst still in rear

facing.

3. DiscontinuetheuseoftheInfantSafetyCushionInsertifthereisinsufcientroomforthebabyor

shoulders reach the Lower Shoulder Height Marker.

Harness Shoulder slots.

Harness tongues and buckle.

Lap strap slots.

Crotch strap slots.

Harness adjuster strap.

Lower shoulder

height marker.

Adjuster button.

REARWARD-FACING BELT PATH;

shown as blue.