Instruction manual

54 55
PRE-INSTALLATION ANCHOR FITTING PRE-INSTALLATION ANCHOR FITTING
IF THE CAR IS FITTED WITH CHILD
RESTRAINT ANCHORAGE POINT
Locate the anchorage point behind the rear seating position.
(Consult the car owners handbook for the location of the
anchorage point). The anchorage point should be directly
behind and central to the restraint. Remove thread plug from
theparcelshelf/oor/roof,etc.andinstallanchorboltand
ttingasshowninFig1.
CAUTION: DO NOT OVERTIGHTEN ANCHOR BOLT.
OVERTIGHTENING MAY FRACTURE OR BREAK BOLT.
MAXIMUM TORQUE IS 20 N.M. (14.75 ft.lb.)
Note:Minimumofvefullturnsofanchorboltisrequired
before tightening force is applied.
IF THE CAR IS NOT FITTED WITH CHILD
RESTRAINT ANCHORAGE POINTS
For Sedans only - Drill 9mm diameter hole in the parcel shelf
on the centre line of the seating position as shown in Fig 3.
Before drilling the hole, check the underside for accessibility.
Install the anchor bolt as shown in Fig 2.
For vehicles other than Sedans - In Australia, consult your
nearestchildrestraintttingstationortrafcauthorityfor
vehicleinspectiontondthebest,correctpositionfor
the placement of the anchorage point, and for the correct
attachment bolt length and use of spacers. In New Zealand,
consult the agent for the vehicle.
Note to Queensland purchasers: The installation of
anchoragepointsmustbeapprovedbyauthorisedofcers
appointedbyQueenslandTransport.Authorisedofcerscan
be sourced from all Queensland Transport Customer Service
and Queensland Ambulance Service Centres.
ONLY USE A 5/16 UNC GRADE 5 BOLT. IF THE BOLT IS NOT THE
CORRECT LENGTH THE CAR MANUFACTURER’S HAND BOOK
CAN PROVIDE ADVICE ON THE CORRECT LENGTH BOLT.
CHILD RESTRAINTS MUST NOT BE ATTACHED TO UNSOUND
METAL OR TO WOOD, OR SYNTHETIC STRUCTURES. WHEN
DRILLING 9 MM HOLE DO NOT DRILL THROUGH FUEL LINES,
FUEL TANKS, ELECTRICAL WIRING, OR RADIO SPEAKERS.
WEBBING STRAPS MUST BE PROTECTED FROM SHARP
CORNERS AND EDGES. THE ANCHOR FITTING MUST BE USED
ONLY AS DESCRIBED ABOVE. IT MUST NOT BE HOOKED ONTO
ANY OTHER OBJECT.
CAR INSTALLATION ACCESSORIES
(From retailers of Safe-n-Sound products)
EXTRA ANCHOR KITS: Available for using the restraint in additional cars.
Re-order no: 0038
EXTENSION STRAPS:Mayberequiredforcarswithoutaxedparcelshelf.
Re-order no: 0035 (length 300mm) or
0036 (length 600mm)
GATED 3-BAR SLIDE (Locking clip): For converting lap-sash seat belt to lap belt, and to obtain a
betterttothecarwherethettedlock-offmaynotbesuitable.Mostcarswillnotneedthis,Re-order
no: 0215.
Front of Vehicle
UPPER ANCHORAGE FITTING
Attachment Bolt
Lock washer
Anchortting
Spacer(s) if
required
Vehicle metal
structure
Vehicle trim
Fig.1.
Attachment Bolt
Anchortting
Spacer(s) if
required
Vehicle metal
structure
Reinforcing
washer (cone
downwards)
Lock washer
Secure nut
UPPER ANCHORAGE
FITTINGS FOR SEDANS
ONLY
Vehicle trim
Fig.2.
Note: Marking on
the top of a Grade 5
Bolt.
Front of Vehicle
Centre line of
seating position
Fig.3.
200mm
min.