Instruction manual

D
HOW TO SETUP
INSTALLING INTO THE CAR
A. Place the restraint rearward facing in the chosen
seating position with the Messy Mat positioned
centrally in the seating position.
B.Lifttheapattheendoftheseatsufcientlyto
access the stabilising bar, pull out stabilising bar
and then gently push bar forward until a click is
heard.Stabilisingbarisnowlatchedinplace.Ret
theap.
C. Undo the buckle and place the straps to each
side.
Then push bar
forward
Pull out
Stabilising
bar
Click
Liftapenough
to access the
stabilising bar
14
15
B
B C
HOW TO SETUP
Infant Safety Cushion Insert
D. Remove Infant Safety Cushion Insert, and
gently lift headrest trim end, then pull backwards
thecentrepanelap,withthecomfortpadfrom
the inner seat of trim.
E. If using a Lap-sash seatbelt, disengage the
rear facing Lock-off. Fully lengthen seat belt and
feed the seat belt through the closest seatbelt
path slot and pass across the seating surface
behind the crotch buckle straps and through the
opposite slot. Follow the blue -
REARWARD
FACING BELT PATH label.
Headrest trim end
E
Pass buckle tongue through slots 1 and 2.
Centrepanelap
Lock-off (open)
Seatbelt path slot
Blue -
REARWARD
FACING BELT
PATH label.
2
1